Exploding Fish Heavy-Duty Replacement Rod Holder Inner Tube Sleeve - 8.5", 0-Degree [2A0007] hats-tag Use Above or Below Water

Use Above or Below Water Level

Connect additional i50 speed displays

The transducer is supplied with a thru-hull / ground sleeve for installation in the bottom of the vessel

while providing mounting for Grand Slam outrigger mounts

Typical Uses: bilge pump out

Exploding Fish Heavy-Duty Replacement Rod Holder Inner Tube Sleeve - 8.5", 0-Degree [2A0007] hats-tag Use Above or Below WaterHeavy Duty Replacement Rod Holder Inner Tube Sleeve 8. 5", 0 Degree These are the Heavy Duty rod holder Inner Sleeves (FXD ROT) for 30 degree 15 degree 00 degree rotating and fixed rod holders. They are fully engineered and made of a UV resistant rubber compound. Note: It is recommended that a small application of either Sikaflex or Loctite 480 be applied after installation between the rubber and stainless tube down at the gimbal pin height for extra