Tascam 133 Mains power switch To fit just cut of

To fit just cut of the old tyre clean the bush or bearing and then squeeze these on the a very high tolerance so can hug the old unit

I have now seen two versions of this so have listed them on their own

and a useful spare if you have one of these machines and want to re-cap the electrolytic caps as there is only a few to do here unlike the

switches can go wrong

they are almost a standard size but very very slightly over too allow the shaft to fit in as the shafts were 7mm almost spot on but not less

Tascam 133 Mains power switch To fit just cut ofMains switch used on the Tascam 133 but was probably common in machines of this period